Outback-power-systems GS8048 Quick Start Guide User Manual download pdf

> 90% (blinks if charge parameters are met)

Color

Red

Yellow

Green

≥ 80%

≥ 70%

≥ 60%

≥ 60% off, < 60% solid, < 50% blinks

Battery State-of-Charge

FNDC LED Indicators

Components

900-0153-01-00 Rev A.vsd\Page-1\2013-01-17

MATE3 Programming

IMPORTANT:

Programming should be done by a qualified installer who is trained on programming inverter power systems. Failure to program accurate parameters for the

system could potentially cause equipment damage. Damage caused by inaccurate programming is not covered by the limited warranty for the system.

Contact Technical Support:

Telephone: +1.360.618.4363

Email: [email protected]

Website: www.outbackpower.com

IMPORTANT:

Not intended for use with

life support equipment.

AC Source

Utility Grid, or

AC Generator

Main Electrical Panel

(or overcurrent device for

the AC source)

Electrical Distribution Subpanel

(Load Panel)

Battery Bank

Photovoltaic (PV) Array

(with PV Combiner Box [PV8 or PV12])

Customer-Supplied Components

Charge Controller

FLEXmax 80*

FLEXmax 60*

Optional OutBack Components

PV Combiner Box

PV8

PV12

*Including appropriate Mounting Bracket.

Inverter/Charger

GS Load Center

System Display

and Controller

MATE3 (FW-MB3

mounting bracket)

Communications

Manager

HUB10

HUB 4

GS8048

FLEXnet DC Monitor (FNDC)

Surge Protector

Remote Temperature Sensor (RTS)

Radian System Products

Major Components

GSLC175-PV-120/240

Communication

Manager

(HUB10)

MATE3

System

Display and

Controller

GS8048 Inverter/Charger

GS Load Center

(GSLC)

FLEXmax 80

Charge Controllers

(x2) (Optional)

RADIAN Series

Note: For automatic generator

start features see the MATE3

manual for details.

1 2 3 4

Summary of Contents

Page 1 - RADIAN Series

> 90% (blinks if charge parameters are met)ColorRedYellowYellowYellowGreen≥ 80%≥ 70% ≥ 60% ≥ 60% off, < 60% solid, < 50% blinksBattery State-

Page 2

5. Secure the inverter to the surface using a minimum of 1 wall screw (or other appropriate hardware). 6. Follow the instructions for installing the G

Page 3

Energize/Startup ProceduresPre-startup Procedures:1. Double-check all wiring connections.2. Inspect the enclosure to ensure no tools or debris has bee

Page 4 - General Wiring

NEUL1 L2GRIDL1 L2GENNEUNEUL1 L2OUTRELAYAUX+ -12V AUXSwitchINVRemoteBattery TempCharge Controller #1Charge Controller #2L2NAC SubpanelLoads(120 Vac) L